AIR/PM/1 - Air Pro Max THP3 Filter
Single THP3 filter for the Air Pro Max for use with solid particulates.
- Respiratory protection to BS EN12941:1999 to cover all dusts generated when working in hard and softwoods, ply, MDF and other timber-based materials.
- Simple to swap over, the filters ensure you are always guaranteed full protection from harmful dusts.
- Nominal protection factor of 500.
- Filter type
- THP3
- Quantity
- One
no spare products
Videos
Air Pro Max Respirator Video
Overview of the Air Pro Max respirator
Product Questions
The Airflow indicator supplied with the Air/Pro Max mask is a great tool to show the efficiency of the filter. It depends on how contaminated the environment is that your working in.
Low airflow indicator check Before using the respirator perform a low airflow indicator check:
1. Ensure that the HEPA filter has been installed correctly as shown in Figure 7 on page 15.
2. Activate the respirator with the on/off switch as shown in Figure 9 and perform the following test, noting the LED indicator.
3. Use your hand to block the airflow outlet as shown in Figure 10(2). If the respirator is working correctly the fan will increase in speed.
4. Within approximately 10 seconds the LED indicator will turn from GREEN to RED.
5. The RED LED indicates low airflow.
6. Remove your hand from the air inlet.
7. Switch the respirator off using the on/off switch as shown in Figure 9 to cancel the test.
8. Activate the respirator with the on/off switch once again before use.
Find out more below.
Discolouration of the filter is also a good indication that the filter needs changing.
